The FSM 600 Mixer is a Professional DJ mixer with 6 input channels providing 2 microphone and 10 stereo inputs; the ideal solution for many system requirements.
 
The FSM-600 is essentially a six channel mixer with each channel switchable to two inputs. Channels 1 and 2 are switchable between low impedance microphone and stereo line inputs. Channels 3 to 6 are switchable between A and B stereo line inputs. The A input may be internally selected to RIAA or normal line. These channels are fully assignable to the cross fader. Three band equalisation is fitted to all inputs along with gain and auxiliary send controls. Illuminated push buttons and a 60 mm fader complete the channel controls. Internal settings provide for the unit to be set to individual needs. The output section provides plenty of facilities to cope with the most demanding applications.
 
Main Features
Professional Club / DJ Mixer
10-Stereo / 2-Mic Inputs
Fully Assignable Crossfader / Stereo Channels
Individual Circuit Cards Per Channel
 
Features:
Four of the stereo inputs are selectable between line and RIAA.
Outputs include Main, Booth, Zone, record, auxiliary, trigger and sub bass.
The input channels have 3 band EQ selectable for +-10, +-5 or no EQ.
Voice over facility and microphone compression selectable.
Music mute connection for possible fire alarm trigger.
Individual internal gain trims for reducing input signal to stop clipping.
Headphone monitoring with a split cue facility.
Assignable cross fade on channels 3, 4, 5 and 6.
Available in either red or black finish.
 
Figures:
Distortion <0.02% typically <0.005%
Max Output level +20db
Eq set flat 20Hz-20kHz +-0.5db

Input Channels 1 and 2
Input selector switch selects input used. M = microphone (XLR connector). L = stereo line (phono connectors).
2 parallel pairs of phono sockets allow easy parallel of source to a second input if required.
LEDs and label area clearly show which input is in use.
Gain control sets input gain level. Check by selecting PFL and adjusting so that V.U. meter just peaks into red.
3 band equalisation provides ±10dB control, internal jumpers allow selection of ±5dB or no E.Q.
Mute push button cuts the channel signal when depressed (switch illuminated). It does not cut the auxiliary send.
PFL (pre-fade listen) routes the channel signal to the monitoring system (V.U. meter and phones). If more than 1 PFL is selected the sum is routed to the monitoring system. If no PFL is selected the monitoring system reads main output.
60mm channel fader.
 
Input Channels 3 and 6
Input selector switch selects input used. A = input A B = input B. Input B is always a stereo line input (internal jumpers selects input A to be either RIAA magnetic cartridge or a standard line input. (phono connectors)).
LEDs and label area clearly show which input is in use.
Gain control sets the input gain level. Check by selecting PFL and adjusting so that V.U. meter just peaks into the red.
3 band equalisation provides ±10dB control, internal jumpers allow selection of ±5dB or no E.Q.
Auxiliary send allows a separate mix of channels summed to the auxiliary output (stereo bus). Internal jumpers allow the auxiliary pot to function pre or post channel fader.
PFL (pre-fade listen) routes the channel signal to the monitoring system (V.U. meter and phones). If more than 1 PFL is selected the sum is routed to the monitoring system. If no PFL is selected the monitoring system reads main output.
60mm channel fader.